Our World RGB SSD – HDD Drive Cover

We recommend routing/plugging in the LED cable (If RGB) before mounting for an easier installation. To mount our acrylic Drive Covers, you will need to first apply the included double-sided tape circles to the back of your cover (note: we recommend installing these on the corners of the cover and not the drive itself to avoid attaching it to the LED strip area (If RGB). Peel the red backing off the 3M double-sided tape, position the drive cover over the drive and press down firmly to secure it on top.

All our RGB Mod Parts come with this connector on the cable by default. See below options on how to power/control the LEDs.

Option 1 (Included): Connect the RGB Cable directly into your motherboards 3 Pin 5V RGB Header, Razer Chroma Addressable RGB Controller, EKWB D-RGB Loop Connect, or your own 5v 3Pin Controller. Make sure not to connect to a 12V 4 pin header, as that will kill the LEDs.

Option 2 (Optional/Sold Separately): To use the RF remote to control your LEDs simply connect the SATA Power Cable to any SATA Power cable from your power supply unit. Connect the other side to the LED connector.

Option 3 (Optional/Sold Separately): To use Corsair iCUE to control and power your LEDs, simply connect the Corsair iCUE cable adapter to the RGB Cable, and then plug in the adapter into a Corsair Commander Pro or Corsair Node Pro unit. Connect the other side to the LED connector. In Corsair iCUE’s software make sure to set the product to *2 LED STRIPS* as ours are denser!

Option 4 (Optional/Sold Separately): Connect to a Gigabyte/Aorus Motherboard Fusion 5V 3 Pin VDG Header. Connect the other side to the LED connector.